Zibro S1731 Manuel de service télécharger pdf (Page 15)

ancelling “OFF Timer”

Press the timer fixing button “OFF”. The timer lamp of the indoor unit goes off.

“SLEEP Timer”

Pressing this button starts the timer mode that will stop the operation after the setting time.

Press the “SLEEP” button during the operation.

The setting time repeats the following mode by pressing the button:

Continuous operation (Sleep Operation: OFF). The operation stops after passing

the setting time.

Sleep Timer features

During Cooling Operation

The setting temperature rises 0.6°C after 30 minutes of Sleep Timer ON, and rises

0.6°C again after 30 minutes of the first temperature rise.

During Heating Operation

The setting temperature drops 0.6°C after 30 minutes of Sleep Timer ON, and

drops 0.6°C again after 30 minutes of the first temperature drop.

Emergency and test operation

Emergency Operation

• The emergency operation is needed only when the remote control can not be used.

• When you press the Emergency Operation Switch, you will hear a beep and the emergency operation

starts.

• Emergency operation is preset for the following two modes, only based on the temperature of the

oom at the time of operation.

Temperature

Operation

mode

Designated

temperature

Timer mode Air flow

Above 23°C Cooling 26°C Continuous Automatic

Below 23°C Heating 23°C Continuous Automatic

NOTE

• When you select both “OFF Timer” operation and “Sleep Timer”

operation, the latest setting precedes the first setting.

• “Sleep Timer” operation has no need to set the present time.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Pas de commentaire

Zibro S1731 Manuel de service Page 15